Order the Potassium permanganate from the link. caring for antelope horns Use a piece of sandpaper to sand down any rough edges left on the antler after cutting. You don't have to use baking soda or anything other than lots of fresh water to rinse it out. taxidermy eyes I'm picking up a bandsaw this week so cutting won't be a problem either. Be sure not to use a completely soaked cloth, as too much water will do more harm than good. Outdoors in general, hunting fishing. For a better experience, please enable JavaScript in your browser before proceeding. Deer and Small Game Hunting and Trail Cams. Using some good old elbow grease, soak the antlers for a few minutes or just start scrubbing them with a wet washcloth and the soap. It is important to put the antler in a vise, rather than holding it with your hand, to avoid injury. This whole valley is pretty much full of elk. I have used the hydrogen peroxide to whiten a couple of skulls to good effect, similiar to how it's described in the link above from jajimi. Almost every outdoorsman has some type of animal hanging on their wall. Consider using a clamp to hold the skull in place, so that it doesnt move while you saw it. Allow the paint to dry and repeat if necessary. I've done a few with special dark oak wood stain and they came out great. Leather Lady Productions all rights reserved 2006-2023. Fortunately, a little TLC with wood stain can go a long way to restoring the condition of the antlers. You can polish antlers using many products -- including shoe polish. dusting rug mounts I make anter lamps and use Old English to give the anters a uniform apperance. Step 2 Bring the antlers inside. Just be somewhat gentle and go in the direction of the feathers. I wonder if anyone know how to whitening stag horn which has been darkened probably by age? He knows what condition it was in before you took it to clean up. Leather Lady Productions all rights reserved 2006-2023 I cut what I needed and set on a mason jar with the lid on but not tight, you will get foaning and expansion. However, if the antlers are very dirty, then you'll want to soak them in soapy water for a few minutes (Dawn dish soap works well). http://www.dakotaskulls.com/index.shtm. on Introduction. How long should they be cut? caring for sheep horns Shrek Texture Pack Minecraft, They are one of three items that can be obtained by killing and skinning an Elk. ELK FACTS. 1- Buy a light wood stain and apply it very lightly with a rag. June 25, 2013 Then I would use a water base clear finish on them. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register. taxidermy tips and tricks Actually standard woodworking tools (saws, dril bits, lathes, sand paper, etc.) "I Never Met A Knife I Didn't Like", (Will Rogers), leaving it under the sunlight for some days may work. For antlers in a laurel wreath shape, start by lightly drawing an oblong circle with a pencil- Im using a purple felt tip marker to make my instructions stand out.